![]() Identified by 821-1312-02 printed on the cable. ![]() Replace the cable that connects the wireless board to the logic board compatible with the A1278 Early 2011 to Mid 2012 13 inch Unibody MacBook Pro laptop. Drive Upgrade & Clone: USB-C to SATA III Adapter cable enables quick access to 2. MacBook Pro 13' Unibody (Early 2011-Mid 2012) Airport/Bluetooth Cable. In particular, be sure you have at least one backup of all your data. ASM235CM, USB-SATA Search: Asm235cm Firmware. ![]() If you're especially concerned about losing track of where things go, you can put the tape on a piece of paper and write down the location of each screw next to where you've taped it.Īll the standard warnings about opening your computer apply here. ![]() One tip for doing this procedure - use a long roll of tape stuck to your desk to keep track of the screws you remove at every step. The installation instructions for the Data Doubler can be found here and cover the tools required for all MBP models. Unless they are required for the OptiBay, I don't think you'll need any Torx drivers. Configurable options: 1TB 5400-rpm hard drive 128GB solid-state drive 256GB solid-state drive 512GB solid-state drive Size and Weight Height: 0.95 inch (2.41 cm) Width: 12.78 inches (32.5 cm) Depth: 8.94 inches (22.7 cm) Weight: 4.5 pounds (2. You don't need to provide a SATA cable, rather the frame (OptiBay or Data Doubler) used to mount the hard drive in place of the optical drive will use the SATA cable formerly employed by the optical drive.Īs for tools, I believe you will only need a Phillips screwdriver (size #00 or #0, I can't recall). I made a similar modification to my 13" mid-2009 MacBook Pro and used the OWC Data Doubler. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |